MANUAL COATING MACHINE VORTEX L1M

- Sturdy electro-welded sheet metal carpentry machine
- Bar manual centering
- Machined rotating ring with nr. 2 coil holders
- Access door protected by interblocking safety limit switch
- Electric cabinet equipped with a control panel for manual and automatic working cycles control
- Power: 380 V – 50 Hz
- Max. air pressure: 6 bar
COIL DIMENSIONS
PAPER: Ext. Ø 380 mm hole 50 and height 100 - 120 mm
POLYTHENE: Ext. Ø 300 mm hole 50 and height 100 - 120 mm
PROTECTIVE FILM: Ext. Ø 300 mm hole 50 and height 100 - 120 mm
COATING DIMENSIONS
Round : Min. Ø 50mm and Max. Ø 220 mm
Square: Min. 40x40 mm and Max. 200x250 mm
Length: Min. 1,5 meters
The manual coating machine Vortex L1M is ideal for winding aluminum profiles in a protective film. Profiles loading, protective film cutting and profiles unloading are manual.
The machine is made of electro-welded sheet metal sturdy carpentry. Following the placement order, the line consists of idle rollers in its front part, preceding a machine body, which includes a bar manual centering to align profiles at the center of the machine and two protective film coil holders assembled on a rotating ring. These coil holders have a sprung clutch for film tension adjustment.
A door protected by an interlocking safety limit switch allows the access to the machine, allowing the opening only by a stationary rotating ring, while other idle rollers are in the rear part.
The line is equipped with an electric cabinet with a control panel for manual and automatic working cycles control and cycle on/off buttons on both loading and unloading sides.